A temporary fuel-cost spike with unchanged capacity initially causes:
AD–AS: shocks, gaps & adjustment
Name the initial shock, find the short-run equilibrium, then tell a separate story about wages, expectations, and the return to potential output.
Build the model
AD slopes downward through wealth, interest-rate, and exchange-rate channels. A change in P moves along AD; autonomous spending changes shift it. SRAS slopes upward when wages or other input prices are sticky, or perceptions adjust slowly. LRAS is vertical at potential output, determined by resources, labor, capital, and technology.
After a demand expansion from potential, output initially exceeds potential. As expected prices and wages rise, SRAS shifts left until output returns to potential at a higher price level. A negative supply shock instead raises prices while lowering output, creating a stabilization tradeoff.
Key ideas
- Aggregate demand
Planned spending on domestic final output at each price level.
- Short-run aggregate supply
Output firms supply at each price level while some wages, prices, or expectations are sticky.
- Potential output
Sustainable output at normal resource utilization; not the maximum physically imaginable production.
- Recessionary gap
Actual output below potential, typically accompanied by cyclical unemployment.
- Stagflation
Higher prices combined with weaker output following an adverse supply shock.
- Self-correction
Wage and price-expectation adjustment changes SRAS over time; adjustment need not be immediate or painless.
Formulas
Measure the gap, then explain it
Potential output is 800. A demand slump reduces output to 760 with no change in productive capacity.
Calculate the gap: .
Draw AD shifting left, SRAS unchanged initially, and LRAS fixed at 800.
With no policy response, falling expected prices and wages eventually shift SRAS right.
A −5% output gap. Long-run output returns to 800 under the model assumptions; the price level is lower.
Shift which curve, which way?
Three-question check
After a pure AD expansion, long-run output returns to potential because:
Output is 990 and potential is 1,000. The output gap is: